Thin compact PCB coils with an integrated driver (so no extra DriveCells required) & solderable daisy-chained pads, allows you to magically control magnets on top of them, making them dance, jump, and flip!
€4,99
| /
Integrated H-Bridge Driver
Connect it directly to your microcontroller to control the coil's polarity & drive strength
Square-Fit Design
Power more cells with its solderable daisy-chained pads
Ultra-Thin
It's just 1.3mm thin! This is including all the on-board electronics
Jumping Magnets
Keep it fixed and add lightweight magnets on top to make them bounce!
Vibrate
Hide magnets inside lightweight objects, find its resonance & shake things up!
Sound
Bzzz! Add a magnet and drive it between 2kHz-16kHz ~ tune it & turn it into a buzzer!
FlipDot
Pivot a magnet & make it flip
Linear Actuator
Move a magnet on-top the coils
Dice
Use magnetic dice to always roll six!
Use our library & connect it to a CodeCell, ESP32 or any other Arduino board to quickly get started with examples!
Arduino LibraryShare the power of up to 10 Cells together!
Eliminate some wires by daisy chaining the cells. Just solder all the VDD & GND pads to power up to 10 cells at once. The other IN1 & IN2 pads can be either shared by soldering the pads together or uniquely customized with separate wires.
The 5-Cell option, makes it even easier as the VDD & GND are already connected inside the board. So it will only require the IN1 & IN2 signals. Each cell can also be separated from its neighbours.
For more than 10 Cells, check out our 3-Pin 10x10 CoilCell+
Mechanical:
Electrical:
Notes:
Be the first to know about new projects and get exciting deals!
